Contents
1. Instructions for Buttons
1.1 Powering On/Off
1.1.1 Powering on
After confirming that the key switch 
is turned on, press and hold the power button for about 3 seconds, and the bottom light strip will appear in blue.
1.1.2 Powering off
Press and hold the power button for 6 seconds till the screen goes off, indicating that the robot is successfully powered off.
1.2 Pause
Tap on the screen to pause the working robot. Tap again to resume operation.
1.3 Emergency stop
In case of an emergency, press the emergency stop switch to stop a working robot. Rotate the emergency stop switch clockwise, and resume the operation according to the screen tips.
| Caution： |
| Before starting an automatic cleaning task, make sure the robot is powered on and placed below or in front of the visual marker (depending on the position of the marker) for successful positioning at the startup location. |
2. Instructions for Handle
The robot handle connected to the screen is either raised or lowered.
When you need to push the robot or interact with the screen, raise the handle and screen;
When the robot is idle or working automatically, lower the handle and screen.
| Handle raised | Handle lowered |
|
|
3. Cleaning Mode
The robot comes with various modes to cater to different scenarios, including Sweeping, (Carpet) Vacuuming, Dust Mopping, and Scrubbing.
| Cleaning Mode | Description |
| Scrubbing Mode |
In Scrubbing Mode, scrubbing operation will be performed, which is suitable for hard floor cleaning. Remove the side brush. Install the washing brush and the squeegee. Make sure the washing filter is installed in the recovery tank. |
| Sweeping Mode |
In the standard Sweeping Mode, the robot will perform "sweeping+vacuumming+dust mopping" cleaning operation, which is suitable for hard floors cleaning. Install the side brush, sweeping brush, and Mopping-vacuuming part. Make sure the vacuum dustbin is installed in the recovery tank, and the dirty water recovery tank. |
| Carpet Vacuuming Mode |
In the Carpet Vacuuming Mode, the robot will perform "sweeping+vacuumming" cleaning operation, which is suitable for low-pile carpet cleaning. Install the side brush, sweeping brush, and carpet sweeper. Make sure the vacuum dustbin is installed in the recovery tank, and the recovery tank is empty. |
| Silent Mopping Mode |
In the Silent Mopping Mode, the blower is turned off. It is suitable for sound-sensitive cleaning environments. Install the side brush, sweeping brush, and mop head. |
*Refer to PUDU CC1 Operation Guide for more information on how to use the robot.
4. Working Modes
4.1 Manual Cleaning
On the home page, click on "Manual Cleaning", then select the cleaning mode (mopping or sweeping). After clicking on "Start", you can push the robot to perform the cleaning task (Note: when performing manual cleaning, remember to raise the handle and push the robot for cleaning).
4.2 Automatic Cleaning
Before starting an automatic cleaning task, please ensure that the robot is powered on and positioned directly below or in front of the visual marker code (depending on the placement of the marker code). This will ensure that the robot can successfully locate itself at the starting point.
After clicking on "Auto-Cleaning" on the home page, select the desired cleaning task (previously set by the delivery personnel). If no selection is made, the default task will be executed. Click on "Start " to start the task. The robot will begin executing the selected task. (Please note that, in automatic cleaning mode, it is necessary to put down the handle of the screen. Failure to do so may prevent the task from starting properly.)
4.3 Scheduled Task Setting
The robot supports scheduled task setting. After setting up a scheduled task, the robot will automatically execute the task at the designated time, provided that it is properly positioned, has sufficient battery power, and an adequate water level.